What Should I Pay Attention To When Using A Cordless Vacuum Cleaner?
Dec 09, 2021
Four points to pay attention to when using a cordless vacuum cleaner
One. Do not suck foreign objects
1. Nowadays most vacuum cleaners have strong suction power, but you must be careful not to suck metal, broken glass and other hard foreign objects, otherwise it will scratch the air duct and cause damage to the internal hardware.
2. In the course of use, once a foreign body is found to block the straw, it should be shut down and checked immediately, and the foreign body shall be removed before continuing to use
Two. Replace the sealing foot pads in time
1. If the sealing rubber pad in the vacuum cleaner has aged and loses its elasticity, it should be replaced with a new rubber pad in time
2. When there is a lot of garbage accumulated in the dust cup and dust bag, it must be cleaned up in time, and it is not necessary to wait for the dust full indicator to light up.
3. Only by keeping the ventilation path unobstructed can the obstruction cause the decrease of suction power, the heating of the motor and the reduction of the service life of the vacuum cleaner.
Three, check all accessories
1. Clean up the debris in the barrel and all vacuum accessories in time
2. Clean the dust grid dust bag after each work, check for perforation or air leakage, and clean it thoroughly with detergent and warm water and blow dry. It is strictly forbidden to use non-dry dust grid dust bag
3. When cleaning, wipe it with a damp cloth containing water or neutral detergent. The head of the main unit is strictly prohibited to be immersed in water for cleaning. Do not use corrosive detergents such as gasoline or banana water, otherwise it will cause the shell to crack.
Four. Don't use it for too long
1. Do not leave the machine in a continuous working state for a long time, please control the continuous working time within 1 hour, otherwise it will affect the life of the machine
2. When the vacuum cleaner is used for a long time, the suction power will decrease due to the clogging of the filter mesh
